AT&T Definity TN500 Manual de instrucciones descargar pdf (Pagina 126)

11-8 DCP Mode 2 Installation and Administration

________________________________________________________________________________________________

4. The switch to the right of the RJ21X PERMISSIVE connector must be in the down position.

5. Set the eight Make Busy/Enable switches to the enable position (DOWN).

6. Connect one end of a 25-pair cable from the DCP LINE connector on the 46A2.

7. Connect the other end of this cable to the switch cross-connect ﬁeld. Use the following table to patch

a 4-wire DCP LINE circuit to a switch digital port (GPP) circuit. The switch ports use the same wire

combinations.

_ __________________________________________________

Pin Color Function Pin Color Function

_ __________________________________________________

1 W/BL NC 26 BL/W NC

2 W/O Line 1 27 O/W Line 1

3 W/G Line 1 28 G/W Line 1

4 W/BR NC 29 BR/W NC

5 W/S Line 2 30 S/W Line 2

6 R/BL Line 2 31 BL/R Line 2

7 R/O NC 32 O/R NC

8 R/G Line 3 33 G/R Line 3

9 R/BR Line 3 34 BR/R Line 3

10 R/S NC 35 S/R NC

11 BK/BL Line 4 36 BL/BK Line 4

12 BK/O Line 4 37 O/BK Line 4

13 BK/G NC 38 O/BK NC

14 BK/BR Line 5 39 BR/BK Line 5

15 BK/S Line 5 40 S/BK Line 5

16 Y/BL NC 41 BL/Y NC

17 Y/O Line 6 42 O/Y Line 6

18 Y/G Line 6 43 G/Y Line 6

19 Y/BR NC 44 BR/Y NC

20 Y/S Line 7 45 S/Y Line 7

21 V/BL Line 7 46 BL/V Line 7

22 V/O NC 47 O/V NC

23 V/G Line 8 48 G/V Line 8

24 V/BR Line 8 49 BR/V Line 8

25 V/S NC 50 S/V NC

_ __________________________________________________ 



8. Connect a ground strap from the signal ground (SG) to the frame ground (FG) on the 105A.

9. Make sure the cabinet is not connected to power, then connect the mounting power cords to the

cabinet power strip.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 267 268

Sin comentarios

AT&T Definity TN500 Manual de instrucciones Pagina 126