AT&T PagePac Plus AmpliCenter Guía de instalación descargar pdf (Pagina 63)

Audio Source Enable

The primary use for this feature is to allow the PagePac Plus to be used

for door service. If optioned, whenever a selected zone is active (i.e., the

doorbell pushbutton), an audio source (either Telephone Access or

Attendant Access) will be routed automatically to a zone (the door

speaker-phone) selected in "Audio Routing," below. The default for this

option is NONE.

Programming Steps

First access the PagePac Plus system and enter the programming mode

by pressing [

* ] [ * ] and entering your Programming password (if optioned).

You may exit the programming mode by dialing [

# ].

Dial [

] [

] to select Audio Source Enable.

Hear a DOUBLE beep.

Enter the input zone number. Use ALlAS numbers, if optioned.

Otherwise, use Physical zone/group numbers.

Hear a DOUBLE beep.

Enter [

0 ] (NONE), [ 1 ] (AA, Attendant Access), or [ 2 ] (T/R,

Telephone Access) to select the audio source (or none) to be

enabled when this zone is activated.

Hear TRIPLE beeps.

To verify your selection, Dial [

9 ] [ 7 ] and repeat steps 2 and 3, above.

Table 2-24 summarizes the Audio Source Enable options.

Table 2-24. Audio Source Enable

Feature

Mode Option/

Verify

Dial

Listen

For

Zone/Group

Selection

Listen

For

Choose Option

Listen

For

Default

Audio

Source

Enabled

To Select

To Verify

Double

Beeps

Enter the input

zone number

Double

Beeps

0 - None

1 - AA

2 - T/R

Triple

Beeps

None

2-34 Programming The Controller

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 91 92

Comentarios a estos manuales

Sin comentarios

AT&T PagePac Plus AmpliCenter Guía de instalación Pagina 63

Comentarios a estos manuales

Relacionado con productos y manuales para Amplificadores de audio AT&T PagePac Plus AmpliCenter